MITSUBISHI ELECTRIC SDP-Eco 1630 III User Manual
Page 54
SDP-Eco1630 III USERS MANUAL
• The alarm function in this machine has been set to OFF before shipment at
the factory.
(Settings 000 = OFF)
• The consumption rate of rinse water may be different depending on the
settings in the machine. Set the consumption rate with the following
procedure.
[Procedure] (In cases where the current values are changed to "150".)
(1) Push the
key to display the
window.
(2) Select
with the
key, and then push the
key.
(3) When
is displayed, make sure that the cursor is placed
under the setting, and then push the
key.
(4) Push either the
key (Increase) or the
key (Decrease) to set the
settings to "150".
(5) After changing the setting, push the
key to confirm the setting.
(6) Push the
key two times to display the
window.
Use "120 to 160" as a reference value. Adjust the rate of rinse water reduction
depending on the installation conditions of the machine.
(Adjustable range: 50 to 300. Note that using "000" deactivates this function.)
[Notes for adjustment]
(1) When the "Rinse Tank Check" message is displayed.
If the replenishing bottle is empty, decrease the setting.
If there is a lot of rinse water left in the bottle, increase the setting.
(2) To deactivate the software counter function, use "000" as a setting value.
Be sure to reset the counter by "CLR" after you have adjusted the setting.
Note
< Plate Data >
MENU
ENT.
ENT.
Count 150 CLR
ENT.
< Rinse >
< Plate Data >
MENU
- 46 -