MITSUBISHI ELECTRIC SDP-Eco 1630 III User Manual
Page 78
Message
Error contents
ME9
A problem occurred in the heat roller. Please contact the
dealer where you purchased this machine.
ME10
A problem occurred when the punch unit was activated.
Please contact the dealer where you purchased this
machine.
ME11
A problem occurred in the laser adjustment unit. Please
contact the dealer where you purchased this machine.
Punch Un-mounted
The punch is not mounted.
Close front door
The front door is open. Shut the door.
Width not enough
The width of the plate is insufficient for the exposure
width. Replace the plate with one as wide as the
exposure.
Image Error
An internal data transmission error occurred in the SDP-
Eco 1630 III. Re-boot the machine.
If this error occurs frequently, please contact the dealer
where you purchased this machine.
Plate Set error
The plate has not been set correctly. Re-set the plate.
Plate End
The plate ran out. Load a new plate.
Pick up plate
Open the front door and remove a strip type plate
through the plate removal port.
Waste Tank Check
The waste chemical tank is full.
Empty EAC
The EAC chemical ran out. Replenish it.
Empty EST
The EST chemical ran out. Replenish it.
Tray check
The overflow tray has not been set. Set the tray.
I/F error4
An error has occurred in the SCSI communication. If the
error frequently occurs even after the system has been
rebooted, contact your local dealer where you purchased
this machine.
Please set plate
A plate has not been set. Set the plate.
SRAM BOARD ERR #1 A problem occurred in the I/F board. Please contact the
dealer where you purchased this machine.
SRAM BOARD ERR #2 A problem occurred in the I/F board. Please contact the
dealer where you purchased this machine.
SRAM BOARD ERR #3 A problem occurred in the I/F board. Please contact the
dealer where you purchased this machine.
NO SUPPORT DIMM
A problem occurred in the memory module for buffer.
Please contact the dealer where you purchased this
machine.
MEM VERIFIY ERR
A problem occurred in the memory module for buffer.
Please contact the dealer where you purchased this
machine.
3.3V REG. ERR NN
A problem occurred in the I/F board. Please contact the
dealer where you purchased this machine.
SDP-Eco1630 III USERS MANUAL
- 70 -