MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 59)

7.5 Cleaning the processor section
After repeated prepress operations, silver residue from plates, paper dust,
chemicals, etc. may stick to the tank and/or processor rack, and stain
subsequent separations.
- Always clean the sections shown below when you replace the processing
chemical every three months.
- Always follow the procedures in "4.9 Turning OFF the power supply and
inspection at shutdown" on page 34 before shutting down the machine.
You must thoroughly read "1.3 Handling processing chemicals".
• Cleaning the processor rack
1) Turn OFF the main power switch.
2) Lay out the maintenance mat.
3) Open the front door and remove
the replenisher bottle.
4) Discard the SLM-EAC and
SLM-EST into the waste chemi-
cal tank.
5) Hold the handle for the processor
rack section and pull out the
processor rack until it touches the
stopper.
Caution
Note
• Resetting the punch counter
1) Pressing the key bring up the window on the display
panel.
2) Press the key to select the and then Press the key.
3) Press the key when is displayed.
4) When is displayed, press the key to bring up the
display and then select CLR.
5) Press the key resets the punch counter. ENT.
< COUNT••••CLR
<MODE>
PUNCH DRYER > ENT.
ENT. <MODE>
< Plate Data > MENU
Chapter 7 Maintenance
- 51 -
Maintenance
mat
Waste chemical tank
Replenisher
bottle
SLM-EST
waste
chemical
hose
SLM-EAC
waste
chemical
hose