MITSUBISHI ELECTRIC WD-52631 - Manual (Page 46)

46 Chapter 4. TV Menu Settings
channels from memory, naming channels, and saving
favorite channels in custom memory banks.
Note: If using a CableCARD™, the complete list of
available channels is provided through the
CableCARD and the
ANT 1 option is grayed out.
Clock (Setup Menu)
Set the clock if you wish to use the TV’s Timer function
or schedule delayed recordings. You can use either the
manual or auto method to set the clock.
Figure 3. Clock submenu
Setting the Clock Manually
Time
With the hour highlighted in yellow characters, press
repeatedly to slowly increment the hour and associated
AM/PM indicator or press and hold to quickly increment
the hour. Press
ENTER to highlight the minutes in yellow.
Press to set the minutes.
Date
With the month highlighted in yellow characters, press
to select the correct month. Press ENTER to highlight
the day. Press to select the correct day. Press ENTER
to highlight the year. Press to select the current
year.
Time Zone
Select your correct time zone. Press or to select
the time zone for your area (
Atlantic, Eastern, Central,
Mountain, Pacific, Alaska or Hawaii). Press to move
to the
Daylight Savings option.
Daylight Savings
Press or to select either
Applies or Ignore, depend-
ing on whether or not daylight savings time is used in
your area.
Note: If Clock Setting is set to Manual, each time the time
change occurs, you must open this menu and set the
TV’s clock ahead or back.
If you have selected
Auto for Clock Setting, the TV’s
clock adjusts automatically to daylight savings time.
Setup Menu
Figure 2. Setup menu
Language (Setup Menu)
Choose to display the on-screen menus in either English
or Spanish (Español).
To listen to audio in other languages (when available), see
the “Audio Settings” section in this chapter and refer to
“SAP” (analog signal) or “Language” (digital signal).
Memorize Channels (Setup Menu)
For ANT 1/MAIN and ANT 2/AUX
The memorization process performs two scans of all
possible channels on the selected
ANT input. Analog
channels are scanned first, then the process is repeated
for digital channels. Channel memorization may take up
to 15 minutes to complete.
To start channel memorization
1. Highlight an input selection based on your connec-
tions:
Input Condition
Ant 1 Air,
Ant 2 Air When connected to an indoor/outdoor
antenna
Ant 1 Cable,
Ant 2 Cable When connected to direct cable (no
cable box)
2. Press ENTER to start automatic channel memorization.
To stop channel memorization before completion
Press CANCEL.
Channels memorized before you pressed CANCEL are
retained in memory. If you restart memorization, all previ-
ously memorized channels for the selected antenna input
are erased and the process starts over from the begin-
ning.
After channel memorization, press CH / to tune
to memorized channels. Select the Channel menu for
further channel editing, such as adding and deleting