Microsoft G7VP2 - Manual (Page 20)

20
2
Hardware Installation
2.5 Jumper Settings for Power Supply Type
Jumper JP2
Power Supply Type
The Baby AT form factor
system board is designed to fit
into an ATX form factor chassis.
It is equipped with ATX and AT
power supply connectors. Set
JP2 according to the type of
power supply installed.
ATX Power Supply
If you are using an ATX power
supply, set pins 1 and 2 to On
then set jumper JPP according
to the method you would like the computer to power-on/off.
Important:
If JPP pins 2 and 3 is set to On, that is using the AC power to
power on/off the computer, make sure JP2 pins 1, 2 and 3 is
set to Off. Refer to the next section (Jumper Settings for ATX
Power-On/Off Select) for more information.
AT Power Supply
If you are using an AT power supply, set pins 2 and 3 to On. You
do not need to set jumper JPP because this jumper is applicable
only for computers using an ATX power supply.
2-3 On:
AT Power Supply
(default)
1-2 On:
ATX Power Supply
1
2
3
1-2-3 Off:
When jumper JPP is
set at 2-3 On
1
2
3
1
2
3