Maytag HRE21250PC - Manual (Page 31)

31
Drain Valve Washer
Replacement
NOTE: For replacement, use a 17 ⁄
32
″ x 13 ⁄
64
″ x 1 ⁄
8
″ thick washer
available at your nearest hardware store. For ordering a
replacement washer, refer to the “Repair Parts” section.
1. Before beginning turn “OFF” the electrical power supply
to the water heater.
2. Follow “Draining” instructions in the “Service and
Maintenance” section.
3. Turning counter clockwise, remove the hex cap below the
screw handle.
4. Remove the washer and put the new one in place.
5. Screw the handle and cap assembly back into the drain
valve and retighten using a wrench. DO NOT OVER
TIGHTEN.
6. Follow “Filling the Water Heater” instructions in the
“Instructions for Installation” section.
7. Check for leaks.
8. Turn “ON” electric power to the water heater.
Service
Before calling for repair service, read the “Start Up
Conditions” and “Operational Conditions” found in the
“Troubleshooting” section of this manual.
If a condition persists or you are uncertain about the opera-
tion of the water heater, let a qualified person check it out.
Call Maytag Customer Service at 1-800-788-8899.
HANDLE AND
CAP ASSEMBLY
WASHER
Service and Maintenance (cont’d)
WARNING
HAZARD OF ELECTRICAL SHOCK! Before removing
any access panels or servicing the water heater,
make sure the electrical supply to the water heater
is turned “OFF”. Failure to do this could result in
DEATH, SERIOUS BODILY INJURY, OR PROPERTY
DAMAGE.