Philips Magnavox 27MS343S - Manual (Page 5)

5
T he Cable TV signal into your home may be a
single cable (75 ohm) or may include a Cable
Box. In either case, the connection to the TV is easy.
If your Cable TV signal comes directly via
a 75
Ω
coaxial cable, use the following
steps.
1 Connect the Cable TV signal to the
75 OHM ANTENNA INPUT jack on
the rear of the TV. Screw it down tight.
2 Plug the TV’s power cord into a
power outlet and turn on the TV. Set
TV/CABLE to CABLE as detailed on page
11.
Refer to AUTO PROGRAM to set up your
available TV channels. Details are on page
12.
If you have a Cable Box, use the following
steps.
1 Connect the Cable TV signal to the
IN jack on the Cable Box.
2 Connect a separate coaxial cable to
the OUT jack on the Cable Box
and to the 75 OHM ANTENNA
INPUT jack on the rear of the TV.
3 Plug the TV’s power cord into a
power outlet and turn on the TV.
Set TV/CABLE to CABLE as detailed on
page 11.
4 Set the TV to channel 3 or 4 (the
same as the Channel 3/4 switch on your
Cable Box if applicable). Change chan-
nels at the Cable Box.
Basic Cable TV Connection
An RF coaxial cable (to con-
nect the Cable Box to the
TV) may be supplied by the
Cable TV company. It is not
supplied with the TV.
You can connect a Satellite
Receiver the same way you
would connect a Cable Box.
Helpful Hints
Your Cable Box may have separate Audio and Video Out jacks
instead. If so, use audio and video cables to connect the
AUDIO/VIDEO OUT jacks of the Cable Box to the AUDIO/VIDEO
IN 2 jacks on the rear of the TV.
Press TV/AV/EXIT on the TV’s remote control to set the TV to the
VIDEO 2 channel. Change TV channels at the Cable Box.
75 OHM ANTENNA INPUT OUTPUT IN 2
L
R
VIDEO
AUDIO R
L(MONO)
75 OHM
ANTENNA
INPUT
1
75 OHM ANTENNA INPUT OUTPUT IN 2
L
R
VIDEO
AUDIO R
L(MONO)
75 OHM
ANTENNA
INPUT
Cable TV Company
Cable Box
Cable TV Company