Maytag 860S - Manual (Page 33)

33
To prevent kinks, pull the drain hose and the
connecting pipe.
Adjusting the plinth
(Only if you have kick-plate as accessory)
The dishwasher has two kick-plates (certain
models).
The taller one should be used if the machine is to
be 850 - 870 mm high and the plinth depth can
be varied between 45 - 105 mm. The lower one is
to be used if the machine will be 820 - 845 mm
with a plinth depth of between 50 - 105 mm.
Attach the enclosed felt insulation to the kick-
plate (some models).
Set the correct plinth depth as follows:
1. Press the grey catches towards each other
and pull out the holders as far as required.
Press in the catches so that they lock the
brackets in place.
2. Hang the kick-plate onto the holders by
inserting it into the grooves.
Screw the dishwasher into place
If the machine is to be screwed in at the sides,
the enclosed plastic plugs are used for covering
the screw holes. After fixing check that the front
feet are in contact with the floor.
Fitting fixed kick-plate
Fitting strip seal
(on the floorplinth covering plate)
Proceed as follows:
1. Remove the plastic plinth by gripping with
both hands under the plastic plinth(A), and
breaking outwards and upwards.
2. Undo the two screws on the covering
plate(B).
3. Glue the accompanying rubber strip(C) to the
underside of the covering plate (against the
floor).
4. Screw the covering plate back into place.
Adjust the covering plate so that the rubber strip
is just in contact with the floor.
5. Replace the plastic plinth
A
B
x x x
C
Not all models