Motorola MICOM-2ES/2RS/2TS ALE - Manual (Page 70)

MICOM-2ES/2RS/2TS ALE Supplement to Owner’s Guide
• OPT Configure net options, including: sounding, silent network, LQA
request, scan rate, home acknowledgment, monitor acknowledgment,
occupancy detection, master/slave definitions, AllCall options and
tune time.
• GET Copy all parameters from one network to another. This function is
useful if you are defining a new network and wish to base most of its
parameters on an existing network, for instance if you need to use
different frequencies/channels for day and night communication, but
all other net information (such as stations and names) is identical.
• ERAS Erase an entire network from the ALE data base.
After preparing a set of parameters, your entries are checked and any errors are
reported. If you do not correct the detected errors, MICOM-2 will offer to discard the
new set of parameters.
Default Values
Unless you define different values, each net uses the following factory-defaults:
• Net Name No default defined
• Self Address No default defined
• AllCall Send and receive enabled
• AllCall Channel No default defined
• Tune Time No tune time
• Silent No
• Home Acknowledgment Yes
• Monitor Acknowledgment No
• Master/Slave Master
• LQA Request Yes
• Sounding Manual
• Occupancy Check No
• Scanned Channels No default defined.
When programming a new network or other ALE parameters, you do not need to
define all parameters – change only those for which the default values are not
suitable.
56
_________________________________________________________________________________________________