Motorola MICOM-2ES/2RS/2TS ALE - Manual (Page 76)

MICOM-2ES/2RS/2TS ALE Supplement to Owner’s Guide
Using the New Station Address Filter
To help you add new station addresses to the ALE directory of your radio set in a
controlled manner, MICOM-2 has a special ALE address filter. To enable this filter,
enable the Auto Address function on the
PROG>ALE>OPT>AADR menu (this
function can also be enabled by means of the RSS).
When enabled, the address filter compares the source address of each call received
by your radio set with the addresses stored in the ALE directory. When the first new
unlisted address is found, it is stored in a special memory stack, and you are notified
that at least one unlisted address has been detected by adding the option
RCV (F2)
under PROG>ALE , after the NET option. When you want to check the addresses
stored in the stack, you select RCV (F2) and then decide whether to erase an address
or add it to the ALE directory of your radio set.
Up to 20 new addresses can be stored in this stack, which is organized as a FIFO
stack: this means that when a new address, different from all the previously detected
addresses, is received while 20 addresses are already stored, it will replace the oldest
address.
The information on the received addresses is automatically erased when the radio is
turned off; only addresses added to the directory remain in the directory.
➤
To edit the received addresses and add addresses to the ALE directory:
1. Press MENU (F1) and select ALE (F2)
2. When addresses are stored in the new received
addresses stack, you will see the RCV (F2) option.
Press RCV (F2) to display the RCV screen.
RCV
5061
MOTOROLA
ADD ERAS SAVE AMDs
3. You will see RCV screen. The screen displays the
last detected unlisted address. Use the UP/DOWN
arrows to display the desired address (the display is
cyclical).
ALE
PROGRAMMING
MOTOROLA
NET RCV DIR AMDs
4. When the desired address is displayed, press the key corresponding to the
action to be performed:
• To delete the address from the stack, press ERAS (F2).
• To add the address to the directory, press ADD (F1). The address is
removed from the stack
5. To confirm, press SAVE (F4).
6. Repeat the actions until all the desired addresses are
processed. When done, press ESC to end.
If the stack is now empty, the RCV (F2) option is no longer displayed on the ALE
menu.
62
_________________________________________________________________________________________________