MRV Communications EM316E1 - Manual (Page 18)

Fiber Driver
EM316E1/EM316T1
P/N: 1218003-001, REV_O PAGE 18
STEP 3 Insert the module into the NC316BU-xx unit
NOTE: To avoid damaging any components on the module, handle it by the edges, using
your thumb to push it securely inside the chassis. Do not use excessive force, but
make sure the module is fully inserted in the chassis. When the module is
correctly inserted, the PWR LED should illuminate.
STEP 4 Secure the module to the unit, using the screws on the front panel.
FIGURE 1.3 When the module is correctly inserted, the PWR LED should illuminate.
WARNING! Fiber optic equipment can emit laser or infrared light that
might injure your eyes. Never look into an optical fiber or connector port.
Always assume that fiber optic cables are connected to a light source.