Marantz PD6120D - Manual (Page 17)

10
External Speaker Connections
External speakers may be connected to the plasma monitor
to reproduce sound from VIDEO, DVD or RGB signal
sources.
External speakers may be connected directly to the
SPEAKERS terminals or indirectly by connecting a stereo
system amplifier to the audio outputs.
CAUTION: Unplug the plasma monitor and all
connected components before connecting external
speakers. Use only speakers with 6-ohm impedance and
a power input rating of 7 watts or more.
RGB 3
(Digital RGB)
RGB 1
R/CR/PR
L(MONO)
VIDEO 1
G / Y
HD
VD
R
VIDEO 2
VIDEO 3
Y
CB/PB
L(MONO)
R
L(MONO)
R
CR/PR
B/CB/PB
AUDIO 2
DVD1
/HD1
AUDIO 3
AUDIO 1
RGB2
/DVD2
/HD2
EXTERNAL
CONTROL REMOTE
CONTROL CONTROL
LOCK
ON / OFF
SPEAKERS MUST HAVE MORE THAN 7WATT RATING IMPEDANCE 6 OHM RIGHT LEFT AC IN
LEFT RIGHT
To connect external speakers directly to the plasma
monitor:
1. Strip the ends of the speaker wires.
2. Press down the tabs below the SPEAKERS terminals,
insert the speaker wire and release the tab to secure the
speaker wire connection:
[a] Connect the right speaker (located at right side
of the monitor when viewed from the front)
positive (+) wire to RIGHT +.
[b] Connect the right speaker negative (–) wire to
RIGHT –.
[c] Connect the left speaker negative (–) wire to
LEFT–.
[d] Connect the left speaker positive (+) wire to
LEFT+.