Miele DA 8-2 - Manual (Page 15)

Installation instructions
Remove the ventilation grill and
grease filter.
Unscrew the frame (2 screws) at the
front and remove.
Install the extractor into the cut-out,
from below the countertop, so that
the protruding front edge rests on
the countertop.
Raise the rear of the unit and place
the extractor mounting bracket on
the countertop.
Lower the extractor onto the bracket
and align the unit in the cut-out.
Replace the frame and screw it into
the countertop along with the rear
mounting bracket.
Secure the front of the unit by tighte-
ning the clamp from underneath the
countertop.
Replace the two frame-mounting
screws.
Install the control panel and control
knob.
Connect the vent duct to the extrac-
tor, and connect the appliance to the
power supply.
When installing more than one com-
biset, a stainless steel spacer bar must
be placed between units. It is supplied
with its own installation instructions.
Depth
(in
inches)
Width
(= Dimen-
sion B)
(in
inches)
2 zone Combiset
1 combiset
2 combisets
3 combisets
4 combisets
5 combisets 19-5/16
19-5/16
19-5/16
19-5/16
19-5/16 10-7/16"
22"
33-1/2"
45-1/16"
56-9/16"
4 zone Combiset
1 combisets
2 combisets
3 combisets 19-5/16
19-5/16
19-5/16 22-1/16"
45"
68-1/16"
Combination
One 2 zone
+ one 4 zone
Two 2 zone
+ one 4 zone
Three 2 zone
+ one 4 zone
One 2 zone
+ two 4 zone
Two 2 zone
+ two 4 zone
19-5/16
19-5/16
19-5/16
19-5/16
19-5/16
33-1/2"
45"
56 -9/16"
56-1/2"
68-1/16"
Extractor (e.g. DA 8-2)
For installation between two appliances:
-
Dimension B increases by 3-9/16".
For installation at the end of a combination:
-
Dimension B increases by 3-7/8"
Installation instructions
15