Warning, 2. installing fenders and lights – Miller Electric 3000-4AH User Manual

Page 9

Advertising
background image

OM-659 Page 3

3-2.

Installing Fenders And Lights

WARNING

TILTING OF TRAILER can result in personal injury or equipment damage.

•

Use adequate blocks or lifting device to support hitch end while pivoting trailer jack into position (see Section 3-1).

•

Use trailer jack to obtain desired height and to support tongue weight while installing fenders and lights.

rwarn1.1* 3/93

ST-800 015 / ST-000 297-E

Support trailer with jack. Apply parking brake.

1

Fender

2

Support Bracket

Attach fenders and brackets to frame with
3/8-16 x 1-1/4 in hardware. Tighten hardware
to 30 ft lb (40 N

.

m).

3

Ring Terminal Lead

4

Wiring Harness White Ground Lead

5

Tab Connector

Splice ring terminal lead to white lead with
supplied connector (see Figure 3-3).

Secure ring terminal to side rail using 1/4-20

hardware. If hole is not present, drill a 9/32 in
(7 mm) hole in side rail as shown.

Route brown and green leads through
clamps on right inside of frame and out end of
channel.

6

Sleeving

Slip sleeving over leads. Route leads through
back of right taillight bracket.

7

Taillight

8

Tail Hole

9

Stop Hole

Insert stripped end of brown lead into Tail hole
in rear of right taillight. Insert green lead into

taillight Stop hole. Attach taillight to bracket
with 1/4 in hardware.

10 Sidelight

11 Marker Brown Hole

Route stripped end of either supplied short
lead through hole in right trailer frame chan-
nel. Insert lead into top Marker Brown hole.

Splice remaining end of short lead to brown
lead from wiring harness.

Secure sidelight with 10 - 24 hardware.

Install left side taillight and sidelight using wir-
ing harness brown and yellow leads.

LEFT

RIGHT

To Trailer

To Vehicle

Yellow

Brown

Lead

Lead

Sidelight

Brown

Green

Lead

Lead

Ground

(White)

Taillights

(Brown)

Left Stop/

Signal Lamps

(Yellow)

Right Stop/

Signal Lamps

(Green)

Short Leads

Ground Lead

(Ground To Trailer Frame)

Tab Connector

White (Ground) Lead

Taillights

Tools Needed:

7/16, 9/16 in

5/8 in

9/32 in

1

2

3

4

5

6

7

8

9

10

11

Disconnect from vehicle wiring harness
before beginning installation.

Figure 3-2. Installing Fenders And Lights

Advertising