Motorola LS4208 - Manual (Page 91)

RS-232 Interface 6 - 15
RTS Line State
This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or High
RTS line state.
Beep on <BEL>
When this parameter is enabled, the scanner issues a beep when a <BEL> character is detected on the RS-232
serial line. <BEL> is issued to gain a user's attention to an illegal entry or other important event.
*
Host: Low RTS
Host: High RTS
Beep On <BEL> Character
(Enable)
*
Do Not Beep On <BEL> Character
(Disable)