Mitsubishi Motors 4G9 - Manual (Page 147)

www.mivec.co.nz
4G9 ENGINE (E–W) – Front Case and Oil Pump
11A-10-6
PWEE9502
E
May 1995 Mitsubishi Motors Corporation
(4) Tighten the lower oil pan mounting bolts in the sequence
shown in the illustration.
"
E
A
OIL FILTER INSTALLATION
(1) Clean the filter installation surface of the cylinder block.
(2) Apply engine oil to the O-ring of the oil filter.
(3) Screw in the oil filter until its O-ring comes in contact
with the base. Then tighten one more turn.
" F A SEALANT APPLICATION TO OIL PRESSURE
SWITCH
(1) Apply sealant to the threads of the switch.
Specified sealant:
3M ATD Part No. 8660 or equivalent
Caution
Use care not to allow the sealant to plug the oil
passage.
INSPECTION
11300730026
OIL PUMP
(1) Check the tip clearance.
Standard value: 0.06 – 0.18 mm
PWEE9502-K
E
Jun. 2002 Mitsubishi Motors Corporation Revised
<Except for PAJERO io>
<For PAJERO io>
7
6
3
2
9
8
5
4
1
10
Oil passage