Installation, 1 basic connection – Maxtor NVR-2028 User Manual

Page 13

Advertising
background image

11

3. INSTALLATION

3.1 Basic Connection

Please follow the instructions below to connect your WIRELESS NVR-2028 to a LANCAM or a

computer and to choose a mode for connections.

3.1.1 Use a RS-232 cable to install a wireless setting in a LANCAM

Use a RS-232 cable to connect a wireless LANCAM.

I/O

DC 5V

ANT

VIDEO

SD Card

RS-232

ALARM

DC12V

AUDIO

MONITOR

ANT

I/O

NVR

wireless Lancam

RS-232 cable

WAN

LAN

1. Set up all components to both the NVR and LANCAM.

(Screw up the antenna to both the NVR and LANCAM. Screw up the Lens every LANCAM.)

2. Connect the Monitor to the NVR with a BNC cable.
3. Power on the NVR: plug the NVR power cord into the outlet.
4. Power on every LANCAM: plug every LANCAM power cord into the outlet. Make sure the NVR

must power on first before this procedure.

5. Register LANCAM to the NVR:

i.

Connect the NVR and one of the LANCAMs by the RS-232 cable.

ii. Press

the

Setup button to enter the "MAIN MENU" page.

iii. Select the item titled “COMMUNICATION” and presses the Enter button to access the

"COMM. SETTING" page.

iv. Select the item termed "WIRELESS" and push Enter twice to access the "WIRELESS

SETTING" page.

v. Choose the item labeled "OPERATION" and press Enter twice to go to the

"OPERATIONAL SETTING" page.

vi. Select the item titled "ESSID" and push "Enter" twice to get into the "ESSID SETTING"

page.

vii. Give "ESSID" your local wireless network name, and use the "<", ">", "^" and "v" buttons

to change the existing letters to your network name.

viii. Press Enter, select "OK" and go to the "WIRELESS PAGE".
ix. Push

Enter to access the "WIRELESS SETTING" page and go to the item termed

"LANCAM SETUP".

x. Press

Enter, choose "RS-232" and push Enter again, upon which the terms "Waiting"

and "SETUP OK" will flash on at the bottom of the screen.

Advertising