Miller Electric S-22P12 - Manual (Page 17)

OM-181 931 Page 13
3-7. Connecting Weld Cable And Installing Drive Rolls
ST-801 128-B / ST-162 079-A / Ref. S-180 967
1 Weld Cable From Welding
Power Source
Route weld cable from power
source through rear panel and con-
nect to terminal on drive assembly.
Install and secure wire guide. Install
drive rolls and turn drive roll nut one
click.
Only drive gear is adjustable. Turn
adjustment screw in or out until
groove in drive roll lines up with wire
guide as shown.
Remove drive rolls, and clean
grooves using a wire brush.
2 Rating Label Location
Tools Needed:
3/16 in
7/16, 9/16 in
1
Installation
Alignment
2