IBM 1483DSV - Manual (Page 102)

7-4 701344-003
Problem Determination and Maintenance
Mod Size Test
To start this test, highlight Mod Size Test on the System Manager menu and press Enter.
This test displays a test screen for each of the selectable screen sizes. The test screen
changes from Mod 2, to Mod 3, to Mod 4, to Mod 5 each time you press the Enter key. To
exit from this test and return to the System Manager menu, press Reset. An example of
the Mod 2 Test screen is shown below.
Figure 7-3. Mod Size Test
Screen Centering
To center the display area on the screen, use the Up or Down Arrow key to highlight
Screen Centering and press the Enter key. The Centering screen is displayed
(Figure 7-4 on Page 7-5).
Use the Up, Down, Left, and Right Arrow keys to move the Centering screen up, down,
left, and right. When the Centering screen is centered on the display station screen, press
the Reset key to return to the System Manager menu.
Note: The Up and Down Arrow keys do not move the Centering screen up and down
if the display station is operating in 60 or 75 Hz mode.
To return to the factory-set default center, press the F1 key from the Centering screen.
Adjusting the Contrast
If you are using a 15-inch monochrome monitor, you can adjust the contrast by pressing
the F3 and F4 keys.
(24x80) (32x80) (43x80) (27x80)
...............1...............2...............3...............4...............5...............6...............7...............8
.
.
.
.
.
.
.
.
1
.
.
.
.
.
.
.
.
2
.
.
.
.