Integra DHC-9.9 - Manual (Page 45)

45
Turning On the AV Controller
On/Standby
+
-
On Standby
TV
Input
TV CH
TV VOL
--/--- 10 11 12
D.TUN
+10 0 Clear
1 2 3
4 5 6
7 8 9
Input Selector
VCR/DVR CBL/SAT DVD
Tape Tuner CD
Phono
Game/TV
Macro
1 2 3
VCR DVD
CDR/MD
CD Zone 2
Remote Mode
Dimmer
Tape/AMP
Sleep
Receiver TV Dock Cable
SAT
Zone 3
AUX 1 AUX 2
On
Receiver
Standby
Standby indicator
Turning On and Standby
On the AV controller, press the [On/Standby] button.
On the remote controller, press the [Receiver] Remote Mode button, fol-
lowed by the [On] button.
The AV controller comes on, the display lights up, and the Standby indicator goes off.
Pressing the remote controller’s [On] button again will turn on any components con-
nected via
.
To turn the AV controller off, press the [On/Standby] button, or press the remote con-
troller’s [Standby] button. The AV controller will enter Standby mode. To prevent any
loud surprises the next time you turn on the AV controller, turn down the volume before
you turn it off.
Remote
controller
Receiver
On
AV controller
or
Up and Running in a Few Easy Steps
To get your system up and running with the minimum of fuss, here’s a few pointers to help you configure the AV
controller before you use it for the very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See “Automatic Speaker Setup (Audyssey MultEQ ® XT)” on
page 58.
■ Did you connect your TV to an HDMI OUT or COMPONENT
VIDEO MONITOR OUT 1 or 2?
If you did, see “Monitor Out Setup” on page 49.
■ Did you connect a component to an HDMI input,
component video input, or digital audio input?
If you did, see “Video Input Setup” on page 50, “Component Video
Setup” on page 52, or “Digital Audio Input Setup” on page 53
respectively.
■ Did you connect an Integra/Onkyo MD recorder, CD
recorder, or RI Dock?
If you did, see “Changing the Input Display” on page 57.
OPTICAL
COAXIAL
Y
P B
P R
HDMI
OUT IN
TAPE MD recorder, CD recorder,
RI Dock