Icom IC-M90 - Manual (Page 26)

20
8
SET MODE
D Battery voltage indicator “bt”
This function controls display or non-display settings of the
connected battery pack’s voltage when the power is ON.
• The voltage of the connected battery pack is displayed for 2 sec.
after power is turned ON.
D Signal strength indicator “Sl”
The signal strength indicator displays received signal strength
as “S-meter”. This function is convenient to check the signal
strength visually.
• The strength is displayed at 4 steps.
• The antenna mark and 3 bars appear when receiving strong signals.
• The antenna mark only appears when receiving no signal.
D Squelch sensitivity function “SS”
When this function is turned ON, blocking against noise is im-
proved. Therefore the squelch is not easily affected by noise.
D Scrambler code “cd”
There are 32 codes (1 to 32) available for programming. In
order to understand each other, all transceivers in your group
must share the same scrambler code.
Push
Battery voltage
indication OFF (default)
Battery voltage
indication ON
Push
Signal strength indication OFF
(default)
Signal strength indication ON
Push
Squelch sensitivity OFF (default) Squelch sensitivity ON
Push
Scrambler code 1 (default) Scrambler code 32