IBM E74M - Manual (Page 8)

A5
Figure 1 shows the signal cable connections from the monitor to the Video
Graphics Array (VGA) port typical in an IBM PC or PC compatible. This also
applies to any graphics video card for PC-CAD or workstation that has a 15
pin high density (3 row) D-Sub connector.
Power off both the monitor and PC.
Connect the 15 pin VGA connector of the attached signal cable to the output
VGA video connector on the PC and the matching input connector on the rear
of the monitor. The connectors will mate only one way. If you cannot attach
the cable easily, turn the connector upside down and try again. When mated,
tighten the thumbscrews to secure the connection.
Connect the connector of the supplied MIC cable and Audio cable to the jacks
of PC sound card (if available) and the matching connectors on rear of the
monitor.
One end of the AC power cord is connected into the AC power connector on
the back of the monitor. The other end is plugged into a properly grounded
three-prong AC outlet.
Power ON the PC, then the monitor.
If you see the NO SIGNAL message, check the signal cable and connectors.
After using the system, power OFF the monitor, then the PC.
M I C .
O U T A U D I O . I N
Power Cord
Signal Cable
Figure 1.
D-15P
IBM PC
Audio Cable
Mic Cable
Connecting the Monitor