IOGear GBS301 User Manual
Page 21
Advertising
15
Method 2 – Back to Back Pairing
Follow this procedure to pair two (2) Bluetooth Serial Adapters.
19
1
Set one serial adapter to Master (switch 4 = ON), and the other to Slave (switch 4 = OFF)
Upon successful connection, the blue LED on both adapters will turn off and remain off
5
Finished
Note: Once you have paired both Bluetooth serial adapters, if you turn them off, please allow approximately sixty
(60) seconds when turning them back on to re-establish a connection.
1
Turn OFF
2
Set device mode
Make sure both Serial adapters are TURNED OFF
Make sure to set matching Baud rates on both serial adapters; else they will not be able to
communicate. See table 1 on page 9 for additional details.
3
Set baud rate
Basic Configuration
Advertising