Intel V09 - Manual (Page 17)

BIOS Settings Dictionary – Alphabetical
V09 – March 2008
Intel® AMT SOL
Operation
This BIOS setting is
present only on
D945G boards
supporting Intel®
Active Management
Technology.
Advanced >
Management
Configuration • Automatic
• Enabled
• Disabled Allows Serial Over LAN (SOL) to be forced enabled or
disabled. Rate is set to115200 baud.
Intel® ME After
Power Failure Intel® ME > Intel®
Management
Engine
Configuration • Power On
• Stay Off Determines mode of operation if power loss occurs.
Stay Off: Intel® ME will remain off once power is restored.
Power On: Restores ME to the power on state.
Intel® Quick Resume
Technology
This BIOS setting is
present only on
boards supporting
Intel® Viiv˜
Technology.
Power • Enabled
• Disabled Enables or disables Intel® Quick Resume Technology. For
more information, refer to
http://support.intel.com/support/entertainment/viiv/qrt.htm.
Intel® RAID
Technology
This BIOS setting is
present only on
Intel® Desktop
Boards that include
support for RAID.
Advanced > Drive
Configuration • Enabled
• Disabled Enables or disables Intel® RAID technology. If you plan on
configuring your system for Intel® Matrix Storage
Technology, enable this setting before installing your
operating system. For additional information, refer to
http://support.intel.com/support/motherboards/desktop/sb/CS-
012075.htm.
Intel® VT for Directed
I/O (VT-d) Security • Enabled
• Disabled Enables or disables Intel® VT for Directed I/O.
For more information, refer to
http://www.intel.com/technology/magazine/45nm/vtd-
0507.htm
Internal Temp Advanced >
Hardware
Monitoring No changeable
options Reads the thermal sensor in the Heceta chip itself
Interrupt (for the
Parallel Port)
This BIOS setting is
present only when
Parallel Port is set to
Enabled
Advanced >
Peripheral
Configuration • IRQ 5
• IRQ 7 Specifies the interrupt for the parallel port, if Parallel Port is
Enabled.
Interrupt (for the
Serial Port)
This BIOS setting is
present only when
Serial Port A is set to
Enabled
Advanced >
Peripheral
Configuration • IRQ 3
• IRQ 4 Specifies the interrupt for serial port A if serial port A is
enabled.
IOAPIC Enable Advanced >
Chipset
Configuration • Enabled
• Disabled Enables or disables I/O Programmable Interrupt Controller.