iSimple IS713 - Manual (Page 10)

7
7. Warranty
Warranty One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your satisfaction. This warranty
applies only to the original purchaser of this product from an authorized iSimple
® dealer. This warranty
covers any supplied or manufactured parts of this product that, upon inspection by iSimple ® authorized
personnel, is found to have failed in normal use due to defects in material or workmanship. This warranty
does not apply to installation expenses. Attempting to service or modify this unit, operating this unit under
conditions other than the recommended voltage will render this WARRANTY VOID.
Unless otherwise prescribed by law, iSimple
® shall not be liable for any personal injury, property damage
and or any incidental or consequential damages of any kind (including water damage) resulting from
malfunctions, defects, misuse, improper installation or alteration of this product. All parts of this iSimple
®
product are guaranteed for a period of 1 year as follows:
Within the first 12 months from date of purchase, subject to the conditions above, iSimple ® will repair or
replace the product at our discretion, if it is defective in material or workmanship providing it is returned to
an Authorized iSimpleTM dealer, with PROOF OF PURCHASE from an authorized iSimple
® dealer.
Warning: This equipment may be reset by unintentional electrostatic discharge during operation. Ex-
posure to direct sunlight or extreme heat may cause damage or malfunction.
FCC
Caution: Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
FCC Compliance Statement:
1: This device is verified to comply with Part 15 of the FCC Rules. Operation subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inter-
ference received, including interference that may cause undesired operation.
2: This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
“Made for iPod” means that an electronic accessory has been designed to connect specifically to iPod and has been certi-
fied by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
“Works with iPhone” means that an electronic accessory has been designed to connect specifically to iPhone and has been
certified by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
iPod is a trademark of Apple Inc., registered in the U.S. and other countries. iPhone is a trademark of Apple Inc.