iSimple IS713 - Manual (Page 9)

6
f. Continue using the ►► ▐ and ▐ ◄◄ and  until you have selected a song and it is playing.
You should hear this song playing through your radio.
Press the
 to go back one step in the browsing menu (this is like pressing MENU on the
iPod).
To begin browsing again, press the
 4 times to return to the top of the browse menu.
Complete steps c, d, e, and f to select the desired song.
Press and hold the MENU button on the remote for 2 seconds to leave the browse menu.
Now you can use the ►► ▐ and ▐ ◄◄ to skip to the next track, or previous track.
If your audio playback is not clear (there is static / hiss) you may use the dTECT™ auto
scan feature to find a clear signal for use with the WiFli.
Press to activate the dTECT™ technology feature.
Note:
dTECT is a smart FM frequency auto scanning technology developed by iSimple that
makes it easier than ever to find a clear, clean channel on which to play an iPod or iPhone.
When the dTECT feature is activated, the WiFli™ will automatically locate and lock-on to
the best local FM frequency for iPod or iPhone playback. All you need to do is tune your
radio to the matching frequency.
6. Troubleshooting
Issue Resolution
My iPod / iPhone shows “waiting for WiFli™” Disconnect WiFli™ node from iPod / iPhone. Recon-
nect WiFli™ node into the docking port on the iPod
/ iPhone
iPod / iPhone shows “Accessory Connected”
and I can’t manually control my iPod / iPhone Press the MENU button on the WiFli™ remote for
2 seconds; iPod / iPhone will switch back to Basic
Mode allowing use of the click wheel or touch screen.
No iPod text displayed on my radio. Verify the radio supports RDS; verify that the radio is
tuned to the correct frequency
Lots of static or background noise Run (or re-run) dTECT feature or use manual tuning
to find a clear frequency