IOGear GCS1742 - Manual (Page 29)

29
Hotkey Operation
Firmware Upgrade Mode
To set the GCS1742/GCS1744 in firmware upgrade mode:
1. Invoke Hotkey Mode
2. Key in:
upgrade
3. Press [Enter]
Note: The front panel LEDs will flash to indicate that the KVM is in firmware upgrade mode. To exit
firmware upgrade mode, you must power off the switch.
Restore Default Settings
To reset the GCS1742/GCS1744 to its factory default settings, do the following:
1. Invoke Hotkey Mode
2. Press [R] [Enter]