Integra CROMA24 - Manual (Page 114)

114 Assembly\Disassembly
Croma24 Service Manual
7. Remove the C-Bracket Assembly by removing the four
attaching screws. See Figure 5-14.
8. Using a #2 Phillips screwdriver, remove the grounding strap
on the left side of the Slide Shaft.
9. Remove the Slide Shaft using a 3mm hex head driver.
10. Disconnect the Lower Drive Shaft Assembly from the Platen
by removing the 4 attaching screws. See Figure 5-14.
11. Remove the Platen by releasing the 4 securing tabs (2 on each
side) and six screws. Gently lift the Platen off of the Base.
12. Disconnect the Stepper Motor cable from J7 on the MPCB.
13. Disconnect the Stepper Motor ground strap from the MPCB.
14. Raise the Lower Drive Shaft Assembly out of the Base.
Figure 5-15. Stepper Motor Removal/Installation.
15. Remove the Stepper Motor Extension Spring from the
Stepper Motor and the post on the Left Lower Drive Shaft
Bracket. See Figure 5-15.
16. Remove the hardware securing the Stepper Motor to the Left
Lower Drive Shaft Bracket and remove the Stepper Motor.