Integra CROMA24 - Manual (Page 116)

116 Assembly\Disassembly
Croma24 Service Manual
Figure 5-16. Installing Lower Roller Assembly.
3. Lower the Lower Roller Assembly into the Base of the printer
by aligning the bracket guides with the base guide tracks. See
Figure 5-16.
4. Slide the Lower Roller Assembly to the right until the left
lower roller bracket is snug against the bracket stop guide.
5. Route the Stepper Motor wires through the wire access area
and to the wire clamp. Attach the connector to J7 on the
MPCB.