Inter-Tel INT1400 - Manual (Page 29)

17
FIN
D
ING YOUR W
A
Y
INT1400 Cordless Telephone User Guide
Selecting a Ring Tone
The ability to change your ring tone is helpful in close-quartered environments. If
your ring tone is unique, you can quickly identify when a call is ringing on your end-
point.
To select the type of ring tone for your endpoint:
On standby mode, press
on the side of the handset until you hear the
desired ring type. There are three ring tones and vibrate ringer available.
NOTE: When your endpoint is set to vibrate and the handset is charging in the base,
the endpoint rings when a call comes in and the call is answered when you lift the hand-
set off of the base.
Turning the Handset Ringer On/Off
You can temporarily turn the handset ringer off.
To turn the ringer off:
In standby mode, press and hold
on the side of handset for two seconds.
The Ring Off ( ) icon appears in the display.
Returning to Default Operation
You can return your endpoint to default levels at any time. This feature returns vol-
umes to default levels; cancels Do-Not-Disturb, and manual call forwarding.
To return your endpoint to default:
Dial .
A
BOUT THE
T
ELEPHONE
S
YSTEM
As you can see, your INT1400 and Inter-Tel telephone system come equipped with a
lot of “bells and whistles.” To help you understand what everything means, it is rec-
ommended that you read the following information before you use your phone:
• Your telephone system may be programmed for one or two dial tones. Systems
with two dial tones have one for intercom calls and one for outside calls.
• Many features “time out” if you wait too long before performing the next step. If
this happens, you must hang up and start again.
RING/VOL
RING/VOL
3 9 4