IBM x Series 200 - Manual (Page 31)

Diagnostics
23
NDIS 4.0 (Windows NT) driver messages
This section contains the error messages for the NDIS 4.0 drivers. The explanation and
recommended action are included with each message.
Error identifying slot
numbers for the specified
board names. Explanation: The mapping between the board name entered
and the slot number for an adapter could not be established.
Action:
Check the board name for the adapter before issuing
the bind command. If the problem persists, contact your
network supplier.
Can’t unbind specified slot
from AFT group. Make sure
that the slot you specified is
for the primary adapter in an
AFT group. Explanation: The number entered in the unbind command
was not the primary adapter in an AFT group.
Action:
Reissue the unbind command and specify the slot
number for the primary adapter.
LAN adapter at slot nnnn
(Port 0xaa) failed to reset.
Check the state of the
adapter. Explanation: The adapter that you specified could not be
initialized.
Action:
1. Load the driver for the supported adapter.
2. Check that the adapter is seated properly in the slot and
try loading the AFT module again.
If the problem persists, contact your network supplier.
AFT is not supported on this
version of NetWare™. Explanation: The NetWare on your server is not a version
supported by AFT.
Action:
Load and bind AFT only on supported versions of
NetWare (currently version 4.11 and above).
Failed to allocate resources
tags. Explanation: An unknown error has occurred when trying to
allocate needed resources for the AFT module.
Action:
Check server configuration. If the problem persists,
contact your network supplier.
Please unload all LAN
drivers before unloading
AFT.NLM. Explanation: An attempt was made to unload the AFT.NLM
module before unloading the adapter driver.
Action:
Unload the adapter driver before unloading the AFT
module.
Message Description
Table 4. NetWare driver messages for the Ethernet controller.