Invacare Deluxe Three-Position IH6065 series - Manual (Page 12)

SECTION 3—ASSEMBLY
Invacare Mobile Recliners 12 Part No. 1141494
SECTION 3—ASSEMBLY
ƽ WARNING
After ANY adjustments, repair or service and before use, make sure that all attach-
ing hardware is tightened securely - otherwise injury or damage may result.
Assembling the Recliner
ƽ WARNING
Tighten mounting screws securely. Failure to do so may result in bodily injury or
damage to the recliner.
Assembling Models IH6074A and IH6065 series
NOTE: For this procedure, refer to FIGURE 3.1 on page 13.
1. Remove back frame with back cushion from its carton.
2. Lock the rear casters. Work from the rear of the recliner base.
NOTE: Ensure that footrest is in closed position before installing the back frame with cushion.
3. Lift the chair back in an upright position behind the rear seat cross brace.
4. Slide the back tubes into the open tube ends of the rear seat cross brace.
5. Lift the plastic skirt mounted on the bottom of the seat and align behind the rear seat
frame crossbrace (Detail “A”).
6. Align the holes in the skirt to the holes in the chair back by fastening the hardware.
7. Securely tighten the two hex screws to secure the back cushion to the back frame.