Invacare Deluxe Three-Position IH6065 series - Manual (Page 28)

SECTION 5—MAINTENANCE
Invacare Mobile Recliners 28 Part No. 1141494
Replacing Plunger Release Knob
NOTE: For this procedure, refer to FIGURE 5.10
1. Remove glide from end of frame.
2. Remove retaining ring from end of plunger pin.
3. Slide plunger release knob off the plunger pin.
4. Lift plunger pin and spring out of the
frame tube.
5. Insert new plunger pin and spring into
the frame so that grooved end of pin
extends below the frame tube.
6. Place plunger release knob over the
plunger pin.
7. Snap the retaining ring into groove of
the plunger pin.
8. Replace the glide into the end of the
frame.
FIGURE 5.10 Replacing Plunger Release
Knob
Removing/Installing the Side Panel
NOTE: For this procedure, refer to FIGURE 5.11.
Removing Side Panels
1. Press the push buttons near the bottom of the right side panel.
2. Hold the push buttons in while pulling the panel outward.
3. Repeat STEPS 1 and 2 for the other side
panel.
Installing Side Panel
1. Slip the top of the right side panel into
the mounting tab.
2. Push the side panel upward until the
side panel fit into the side frame.
3. Pop the side panel into position when
the push buttons are visible, through
the push pin holes, near the bottom of
the side frame.
FIGURE 5.11 Removing/Installing the Side
Panel
Plunger Pin
Spring
Glide
Plunger Release Knob
Retaining Ring
Frame
Frame Tube
Plastic
Keeper
Push Buttons
Side
Panel