IBM Print System QMS 1725E - Manual (Page 55)

Connecting to the Network
4-3 Connecting to an Ethernet Network
Thin-Wire Ethernet
Thin-wire Ethernet connections use BNC connectors.
» Note: Unless the BNC “T” connector described in steps 1 and 2 is already
installed on the thin-wire Ethernet cable, your network’s operation is
disrupted during the connection process. See your network administrator
before continuing.
1 Turn off the printer and unplug the power
cord.
2 Attach one section of thin-wire Ethernet
cable to one end of the BNC “T” connec-
tor.
» Note: If the BNC “T” connector is already
installed, go to step 3.
3 Attach another section of thin-wire Ether-
net cable or a 50 ohm terminator to the
other end of the BNC “T” connector.
4 Attach the BNC “T” connector to the BNC Ethernet port.
5 Plug in the printer’s power cord.
6 Turn on the printer.
To
printer
port