Interlink electronic L485SIB - Manual (Page 14)

14
www.ultrachefgrills.com
Problem Possible Causes Solution
Burners burn with yellow
flame, accompanied by
the smell of gas. Possible spider web or other debris, or
improper air shutter adjustment. Thoroughly clean burner by removing.
See general maintenance instructions.
Open air shutter slightly according to
combustion air adjustment instructions.
(This must be done by a qualified gas
installer.)
Flames lift away from
burner, accompanied
by the smell of gas, and
possibly difficulties in
lighting. Improper air shutter adjustment. Close air shutter slightly according to
combustion air adjustment instructions.
(This must be done by a qualified gas
installer.)
Humming regulator. Normal occurrence on hot days. This is not a defect. It is caused by internal
vibrations in the regulator and does not
affect the performance or safety of the
gas grill. Humming regulators will not be
replaced.
Burners will not cross
light each other. Plugged ports at back of burner. Clean burner ports. See burner
maintenance instructions.
“Paint” appears to be
peeling inside lid or hood. Grease build-up on inside surfaces. This is not a defect. The finish on the lid
and hood is porcelain, and will not peel.
The peeling is caused by hardened grease,
which dries into paint-like shards, that
flake off. Regular cleaning will prevent this.
See cleaning instructions.
Infrared burner (if
equipped) flashes back
(during operation the
burner abruptly makes
a loud “whoosh” sound,
followed by a continuous
blow-torch type sound
and grows dim.) Ceramic tiles overloaded with grease drippings
and build-up. Ports are clogged.
Burner overheated due to inadequate
ventilation (too much grill surface covered by
griddle or pan.)
Cracked ceramic tile.
Leaking gasket surrounding the ceramic tile, or
a weld failure in the burner housing.
Turn burner off and allow to cool for at
least two minutes. Relight burner and
burn on high for at least five minutes or
until the ceramic tiles are evenly glowing
red.
Ensure that no more than 75% of the
grill surface is covered by objects or
accessories. Turn burner off and allow to
cool for at least two minutes, then relight.
Allow burner to cool and inspect very
closely for cracks. If any cracks are found,
contact your authorized Napoleon dealer
to order a replacement burner assembly.
Contact your authorized Napoleon dealer
for instructions on ordering a replacement
burner assembly.