Interlink electronic L485SIB - Manual (Page 26)

26
www.ultrachefgrills.com
13. Side Burner Installation
Insert (4) ¼-20 x 5/8” screws through the washers into the threaded holes in the side of the base; do not tighten all
the way. Slide the assembled side burner over the screw heads and finish tightening. Fit the orifice into the burner
tube and secure with the hose retainer clip supplied. Attach the wire from the manifold to the side burner electrode.
4 x N570-0082 (1/4-20 X 5/8”) 3/8”(10mm) 4 x N735-0001 (insulated washer)
Fit orifice into burner
tube and secure with hose
retainer clip supplied.
1 x N160-0016 (clip)
485RSB MODEL
14. Cabinet Door Installation
Install door handle onto front of door using (2) #14 x 1/2” screws per door.
Insert pivot rod through hole on inside top of door. Holding door in one hand, direct pivot rod into hole in underside of
front cabinet support. Once secure, let rod slide down and through hole in bottom of door and into bushing in bottom shelf.
WARNING!
Do not over tighten screws, as this will cause the handle to crack.