Dynamic range control, Karaoke vocal – Integra DPS-9.1 User Manual
Page 49
49
DPS-9.1 US_E 29343004
Note
Depending on the disc, 6 channel sounds may not be output via the MULTI
CHANNEL OUTPUT/ANALOG OUTPUT jacks.
Dynamic Range Control
DVD-V
Off:
Full dynamic range is maintained.
On:
Dynamic range is reduced.
Notes
• This function works only during playback of Dolby Digital recorded discs.
• The level of Dynamic Range Reduction may differ depending on the DVD.
Karaoke Vocal
DVD-V
Off:
The primary vocal is not output.
On:
The primary vocal is output when it is recorded on the
disc.
Notes
• The vocal output feature is used during playback of Dolby Digital (multi-
channel) recorded DVD KARAOKE discs. This feature allows you to turn
off vocal audio tracks, or restore them for background accompaniment.
• When playing KARAOKE, connect appropriate audio equipment such as
an amplifier to the DVD player.
Adjusting the delay time:
When enjoying 5.1ch surround playback, it is ideal to choose a listening
position that is the same distance from each speaker. By adjusting the
delay time of center/surround speakers, you can virtually create an ideal
listening environment (as if the center/surround speakers were at their
ideal locations respectively as below).
Center Channel Delay
0 msc:
When Df equals Dc.
1 msc:
When (A) is approx. 34 cm (13 inch)
2 msc:
When (A) is approx. 68 cm (27 inch)
3 msc:
When (A) is approx. 102 cm (40 inch) . . .
*(A)=Df – Dc
Get your optimum value (0, 1, 2 . . . 5) dividing (A) by 34.
Surround Channels Delay
0 msc:
When Df equals Ds.
1 msc:
When (B) is approx. 34 cm (13 inch)
2 msc:
When (B) is approx. 68 cm (27 inch)
3 msc:
When (B) is approx. 102 cm (40 inch)
*(B)=Df – Ds
Get your optimum value (0, 1, 2 . . . 15) dividing (B) by 34.
Note
Depending on the DVD-Audio, the audio may be output with delay
times of 0 ms regardless of the setting.
3
Select “Test Tone” and press
ENTER
.
The DVD Player outputs a test signal to each speaker when it is
in stop mode. When playing a DVD-Video, it substitutes the
current sound for the test signal.
Press / to select the receiving speakers, and adjust the
volume of each speaker at the same level by pressing / .
If all the volume levels cannot be equalized, adjust them on the
amplifier.
Press
ENTER
again to turn off the test tone once adjustments
are complete.
FL
SW
FR
SL
SR
(A)
(B)
Ds
Df
Dc
Ideal location of a
center speaker
All speakers should
be located within a
circle with a radius
of Df.
Ideal location of a
surround speaker
DPS-9.1(US_E)p44-55.p65
10/11/00, 19:11
49