Intel 3945ABG - Manual (Page 66)

zeelans.com). NOTE: Contact your administrator to obtain the domain name.
■
Password: Specifies the user password. The password characters appear as asterisks. This
password must match the password that is set in the authentication server.
■
Confirm Password: Reenter the user password.
2. Click OK to save the credentials.
3. Click Connect to connect to the selected wireless network.
If you did not select Use Windows logon on the Security Settings page and also did not configure
user credentials, an Enter Credentials message appears when you attempt to connect to this
profile. Enter your user name, domain, and password. Click OK to access the profile.
4. Click OK to close Intel PROSet/Wireless.
Set up a Client with WEP Data Encryption and EAP-SIM NetworK Authentication
EAP-SIM uses a dynamic session-based WEP key, which is derived from the client adapter and RADIUS server, to
encrypt data. EAP-SIM requires you to enter a user verification code, or Personal Identification Number (PIN), for
communication with the Subscriber Identity Module (SIM) card. A SIM card is a special smart card that is used by
Global System for Mobile Communications (GSM) based digital cellular networks. To add a profile with EAP-SIM
authentication:
1. On the Profile page, click Add to open General Settings.
2. Profile Name: Enter a profile name.
3. Wireless Network Name (SSID): Enter the network identifier.
4. Operating Mode: Click Network (Infrastructure).
5. Click Next to access the Security Settings.
6. Click Enterprise Security.
7. Network Authentication: Select Open (Recommended).
8. Data Encryption: Select WEP.
9. Click Enable 802.1x.
10. Authentication type: Select EAP-SIM.
EAP-SIM authentication can be used with:
●
Network Authentication types: Open, Shared, WPA - Enterprise and WPA2 - Enterprise
●
Data Encryption types: None, WEP, TKIP, AES-CCMP and CKIP
EAP-SIM User (optional)
1. Specify user name (identity): Click to specify the user name.
●
User Name: Enter the user name assigned to the SIM card.
2. Click OK.
Set up a Client with TLS Network Authentication
These settings define the protocol and the credentials used to authenticate a user. Transport Layer Security (TLS)
authentication is a two-way authentication method that exclusively uses digital certificates to verify the identity
of a client and a server.