Intellinet Network Solutions 524957 - Manual (Page 30)

30
ROUTER SETUP
3.3.3 PPPoE
This connection type (Point-to-Point Protocol over Ethernet) is typically
used with DSL and ADSL service.
Address Mode: Select whichever service you’re provided.
IP Address: If you select Static PPPoE, you must enter an IP address
here.
PPPoE Account: Enter the PPPoE username provided by your ISP.
PPPoE Password: Enter the PPPoE password provided by your ISP.
Please retype your password: For confirmation.
MTU: The MTU (Maximum Transmission Unit) setting specifies the
largest packet size permitted for network transmission. Most DSL
users should use the value 1492.You can set MTU manually, and
you should leave this value in the 576 to 1500 range. NOTE: If the
value entered isn’t in accord with the value the ISP provides, it can
cause problems, such as failure to send e-mail or to browse. (If such