IBM EDR1600 - Manual (Page 43)

Administrator’s Guide and Operating Instructions
39
and then select one of the options from Download to floppy or
Upload from floppy. To revert all the configuration setting to
default value, click on the Factory Setting bottom.
Main Monitor Sharpness – The slider bar is for adjusting the
sharpness of the images shown on the main monitor screen. To set
the sharpness, click on the slider and drag the mouse, to left is for
sharper images, to right is for less sharp ones.
Note : The V 2.0(and later version) software can support Networking for either
30 FPS(NTSC) /25FPS(PAL) or 60FPS(NTSC)/50FPS(PAL) recording
rate models.
The system requires 128 MB DRAM and LAN card, please contact the
local distributor for system upgrade.