Intelligent Motion Systems Modular LYNX System - Manual (Page 11)

1 - 11
Modular L
YNX System
Modular LYNX System 12.05.2003
3. Holding the LYNX System at an angle
away from you, lower the upper slot of
the DIN rail attachment onto the top
edge of the DIN rail. Snap LYNX system
into place. Figure 3.2.
4. Insert #6 X .250 L set screw (provided)
into the TOP threaded insert located
between the #6 screws on each end
plate. Figure 3.3. Tighten until 12-14 in/
oz. This will keep the system from sliding
on the DIN rail.
To Remove the LYNX System from the DIN Rail:
1. Loosen the set
screws located in
the TOP threaded
insert between the
#6 screws on each
end plate.
2. Grasp the pull-tabs
located on the
bottom of the DIN
Rail brackets to
release the LYNX
system from the
DIN Rail
(Figure 3.3 - C&D)
while gently lifting
the front of the
LYNX system.
3. Lift the LYNX
System Away from
the DIN Rail.
A
B
C
DIN Rail Bracket A
LYNX System C
B DIN Rail
Figure 3.2: Installing the LYNX System on a DIN Rail
# 6 X .250 Set Screw (Top Location Only)
12-14 in/oz torque.
D
A
B
C
D
DIN Rail Bracket A
Pull Tab C
B DIN Rail
E Removal from DIN Rail
E
Figure 3.3: Removing the LYNX System from the DIN Rail
NOTE: The DIN Rail Mounting option should only be used on
STATIONARY Systems. It is not designed for transport!
N