Interquartz IQ560E - Manual (Page 24)

25
HEADSET MIC ADJUST CONTROL
This control allows many different headsets on the Australian market to function correctly
with the IQ560E telephone by adjusting the HEADSET’S Microphone sensitivity . The
control is located on the underside of the telephone (see Figure 6). The adjustment can
be made by a small screwdriver or similar implement that will fit into the control slot.
Please see Table 1 as a guide to the correct settings for some popular headsets.
TO MAKE A HEADSET MIC LEVEL ADJUSTMENT :
With the headset connected as per the instructions in this manual:
1. Put the headset on and lift the HANDSET to your other ear and make an out-going
call
2. Pressing the HEADSET key, swap between HANDSET and HEADSET mode (The
indicator will illuminate when the HEADSET is in use) a few times while speaking to
the other party
3. With the other party’s help decide if your voice level is the same when using the
HANDSET and HEADSET.
4. If you sound too loud on the headset, adjust the microphone sensitivity (turn anti-
clockwise) so that your voice level when using the HEADSET matches that of the
HANDSET. Clockwise rotation increases the HEADSET mic output level. Please
see Table 1 as a guide to the correct settings for some popular headsets.
HEADSET POLARITY SWITCH
Located on the underside of the telephone (see Figure 6), this switch provides
compatibility with the two commonly-used headset wiring standards.
Position ‘V’ suits Plantronics Vista Cords and other Headsets wired in the same
configuration (also known as “reversed” wiring mode).
Position ‘P’ suits Plantronics P cords and other Headsets wired in the same configuration
(also known as “normal” wiring mode).
Please see (Table 1) as a guide to the correct settings for most popular headsets.
IQ560E MANUAL ON-LINE VERSION_070518.p65 2007/5/18, ¤W¤И 09:56 25