Icom IC-V8 - Manual (Page 31)

22
5
REPEATER OPERATION
■
Offset frequency
When communicating through a repeater, the transmit frequency is
shifted from the receive frequency by an amount determined by the
offset frequency.
q Push [8•
SET
] after pushing [A•
FUNC
]
to enter
SET MODE
.
w Push [
Y
]/[
Z
] several times until “±”
and offset frequency appear.
e Rotate [VOL] to select the desired offset frequency.
• Selectable steps are the same as the pre-set tuning steps.
• The unit of the displayed offset frequency is “MHz.”
r Push [#•
ENT
] to fix the offset frequency and exit
SET MODE
.
■
Subaudible tones
Some repeaters require subaudible tones to be accessed. Sub-
audible tones are superimposed over your normal signal and must
be set in advance.
q Push [8•
SET
] after pushing [A•
FUNC
]
to enter
SET MODE
.
w Push [
Y
]/[
Z
] one or more times until
“rt” appears.
e Rotate [VOL] to select the desired subaudible tone.
r Push [#•
ENT
] to enter the selected tone and exit set mode.
USING SET MODE
SKIP
AO
LM
MR
F
TX
75
50
25
Available subaudible tone frequencies (unit: Hz)
67.0 79.7 94.8 110.9 131.8 156.7 171.3 186.2 203.5 229.1
69.3 82.5 97.4 114.8 136.5 159.8 173.8 189.9 206.5 233.6
71.9 85.4 100.0 118.8 141.3 162.2 177.3 192.8 210.7 241.8
74.4 88.5 103.5 123.0 146.2 165.5 179.9 196.6 218.1 250.3
77.0 91.5 107.2 127.3 151.4 167.9 183.5 199.5 225.7 254.1
USING SET MODE
SKIP
AO
LM
MR
F
TX
75
50
25
D