IBM 206 - Manual (Page 23)

Rear view
The following illustration shows the connectors on the rear of the server.
Power cord
Mouse
Keyboard
Parallel
Serial 1
Serial 2
USB 2
USB 1
Ethernet
Video
1 2
Power-cord connector
Connect the power cord to this connector.
Mouse connector
Connect a mouse or other PS/2 ® device to this connector.
Keyboard connector
Connect a PS/2 keyboard to this connector.
Parallel connector
Connect a parallel device to this connector.
Serial 1 connector
Connect a 9-pin serial device to this connector.
Serial 2 connector
Connect a 9-pin serial device to this connector.
USB 1 connector
Connect a USB device to this connector.
USB 2 connector
Connect a USB device to this connector.
Ethernet connector
Use this connector to connect the server to a network.
Video connector
Connect a monitor to this connector.
If you have an optional Remote Supervisor Adapter II (systems-management
adapter) installed in PCI-X slot 2, your server has additional connectors and LEDs.
See the Option Installation Guide for more information about these connectors and
LEDs. In addition, if you install the optional Remote Supervisor Adapter II, you must
disconnect the video cable from the system board and connect it to the optional
Remote Supervisor Adapter II.
Chapter 1. Introducing the xSeries 206 Type 8482 server 11