Icom COMMUNICATIONS RECEIVER IC-R3 - Manual (Page 24)

20
6
SCAN OPERATION
■ Memory (bank) scan
q Select memory mode with [V/M].
w For memory bank scan, rotate [DIAL] while pushing
[FUNC] to select the desired memory bank.
e Make sure the squelch is set to the threshold point.
• Select automatic squelch (AUTO) or a level (1–9) where the
noise is just muted. (p. 11)
r Push and hold [ ↔ ], then rotate [DIAL] to turn the memory
bank scan ON or OFF.
• “ALL” indicates all memory banks are scanned (memory bank
scan OFF); “BANK” indicates the selected memory bank is
scanned (memory bank scan ON).
t Release [ ↔ ] to start the scan.
• Decimal point(s) flashes while scanning.
• To change the scanning direction, rotate [DIAL].
• If the pocket beep function is activated, the receiver automatically
selects the tone squelch function when a scan starts.
y To stop the scan, push [ ↔ ] again.
S1 3 5 7 9
VOL
FM PSKIP
146.100.000
TS 15.0
BANK
M:A00
S1 3 5 7 9
VOL
FM PSKIP
146.100.000
TS 15.0
ALL
M:A00
Bank scan OFF Bank scan ON