Icom COMMUNICATIONS RECEIVER IC-R3 - Manual (Page 27)

23
6
SCAN OPERATION
e Push [ ↔ ] or rotate the tuning dial while pushing [FUNC] to
select the desired scan pause time.
• “2SEC”–“20SEC” : scan pauses for 2–20 sec. on a received sig-
nal.
• “HOLD” : scan pauses on a received signal until it dis-
appears.
r Push [(MODE) SET] to exit set mode.
◊
Setting the scan resume time
The scan restarts after a signal disappears according to the
resume time. It can be set from 0–5 sec. or unlimited.
q Push [FUNC] + [(MODE) SET] momentarily to enter set
mode.
• Select a non-band scope screen in advance for color LCD.
w Rotate [DIAL] until “Scan Resume” or “RESUmE” appears.
• “RESUmE” disappears after 1 sec. and the previously selected
scan resume time and “RE” appears when color LCD is OFF.
e Push [ ↔ ] or rotate the tuning dial while pushing [FUNC] to
select the desired scan resume time.
• “1SEC”–“5SEC” : scan restarts 1–5 sec. after the signal disap-
pears.
• “0SEC” : scan restarts immediately after the signal dis-
appears.
• “HOLD” : scan restarts by rotating [DIAL] only.
r Push [(MODE) SET] to exit set mode.
2 sec. resume time Scan resume time
set mode Scan resumes by
rotating [DIAL] only.
Tone Squelch: OFF
Tone Freq. : 88.5
Duplex : OFF
Offset Freq.: 0.600
Scan Resume : 2SEC
Tone Squelch: OFF
Tone Freq. : 88.5
Duplex : OFF
Offset Freq.: 0.600
Scan Resume : 2SEC
Tone Squelch: OFF
Tone Freq. : 88.5
Duplex : OFF
Offset Freq.: 0.600
Scan Resume : HOLD
10 sec. pause time Scan pause time set
mode Pause scan
Pause Scan : 10SEC
Priority : OFF
Beep Audio : VOLUME
Light : AUTO
A.Power OFF : OFF
Pause Scan : 10SEC
Priority : OFF
Beep Audio : VOLUME
Light : AUTO
A.Power OFF : OFF
Pause Scan : HOLD
Priority : OFF
Beep Audio : VOLUME
Light : AUTO
A.Power OFF : OFF