Invacare Wheelchair - Manual (Page 31)

31
1. Lift up on the release handle and move the back to the
desired position.
2. Check the angle of the back RELATIVE TO THE SEAT
FRAME.
3. If necessary, have the limit switch adjusted. Contact
an authorized Invacare dealer or qualified technician.
LUMBAR.
1. Rotate the knob on the side of the high back Captain's
Seat COUNTERCLOCKWISE until the desired sup-
port is obtained.
NOTE: The knob only rotates COUNTERCLOCKWISE.
REMOVING/INSTALLING CAPTAIN'S
SEAT (FIGURE 6)
Removing
1. Turn the adjustment lock lever to release the joystick
mounting tube from the armrest.
2. Remove the joystick from the wheelchair.
3. HIGH BACK CAPTAIN'S SEATS ONLY - Discon-
nect the limit switch. Refer to DISCONNECTING/
CONNECTING LIMIT SWITCH in this procedure of
the manual.
4. Remove the four (4) quick release pins that secure
the Captain's Seat to the wheelchair frame.
5. Remove the Captain's Seat from the wheelchair.
Installing
1. Push the Captain's Seat down on the wheelchair
frame at the position shown in FIGURE 6.
2. Line up the mounting holes in the Captain's Seat and
the wheelchair frame.
FIGURE 6- REMOVING/INSTALLING CAPTAIN'S SEAT
Adjustment
Lock Lever
Quick Release Pins
Captain's
Seat
Wheelchair
Frame
Mounting
Holes
Joystick
Mounting
Tube
Armrest
Joystick
WARNING
Make sure the Captain's Seat is secured to the
wheelchair frame with the four (4) quick release
pins BEFORE using the wheelchair, otherwise in-
jury or damage can occur.
3. Insert the four (4) quick release pins through the
mounting holes in the Captain's Seat and the wheel-
chair frame until the rings on the quick release pins
are against the mounting holes.
4. Lift up on the Captain's Seat to make sure it is se-
cured to the wheelchair frame.
5. HIGH BACK CAPTAIN'S SEATS ONLY - Connect
the limit switch. Refer to DISCONNECTING/CON-
NECTING LIMIT SWITCH in this procedure of the
manual.
6. Slide the joystick into the adjustment lock lever to the
desired position.
7. Turn the adjustment lock lever to secure the joystick
mounting tube to the armrest.
DISCONNECTING/CONNECTING
LIMIT SWITCH (FIGURE 7)
NOTE: The following procedure is for High Back Captain's
Seat model wheelchairs only.
CAUTION
Disconnect limit switch BEFORE removing seat
or damage to switch can occur.
1. Perform one (1) of the following:
DISCONNECTING - While holding body of limit
switch phono plug, lift up gently.
NOTE: When the limit switch is unplugged the wheel-
chair will NOT operate.
CONNECTING - Plug limit switch plug into the limit
switch phono jack.
Limit Switch
Phono Plug
Limit Switch
Phono Jack
FIGURE 7 - DISCONNECTING/CONNECTING LIMIT
SWITCH
PROCEDURE 10 FWD WHEELCHAIRS
F
W
D
W
H
E
E
L
C
H
A
I
R
S
NOTE: Shroud not shown for clarity.