Intel ATC6430M - Manual (Page 12)

6430M Mainboard Chapter 2 Installation
9
CHAPTER 2
INSTALLATION
2-1 INSTALLATION PROCEDURE
Before installing the computer, please prepare all components such as CPU, DRAM;
peripherals such as hard drive, keyboard, CD-ROM and accessories such as cables.
Then, install the system as following:
- Put CPU / heat sink (refer to Celeron
TM
CPU installation guide or see
the following setup chapter), and DRAM modules on the mainboard.
- Plug add-on cards into PCI slots, if needed.
- Connect cables to peripheral devices, especially for COM2 connector.
- Make sure all components and devices are well connected, turn on the
power and setup System BIOS based on your configuration.
- Install peripheral devices, add-on card drivers and test them.
- If all of above procedures are running successfully, turn the power off
and screw the chassis cover to the chassis.