Icom IC-M504 - Manual (Page 21)

15
6
DSC OPERATION
5
6
■ MMSI code programming
The 9-digit MMSI (Maritime Mobile Service Identity: DSC self
ID) code can be programmed at power ON.
This code programming can be performed only twice.
q Turn power OFF.
w While pushing [MENU], turn power ON to enter MMSI
code programming condition.
e After the display appears, release [MENU].
r Push [MENU] again to enter the DSC menu.
t Rotate [DIAL] to select “S
Se et t u up p,” push [DIAL•ENTER].
y Rotate [DIAL] to select “M MM MS SI I C Ch he ec ck k,” push
[DIAL•ENTER].
u Rotate [DIAL] to set the specific 9-digit MMSI code.
• Push [16•9] or [CH/WX•DUAL•U/I/C] to move the cursor forward
or backward, respectively.
• Push [CLR] to cancel and return to the set up menu.
i After entering the 9-digit code, push [DIAL•ENTER] to set
the code.
• Returns to the set up menu.
o Push [CLR] or rotate [DIAL] to select “E Ex xi it t,” push
[DIAL•ENTER].
• Returns to the DSC menu.
• Repeat again to return to the normal operation condition.
--DSC --DSC Menu-- Menu--
MMSI Check MMSI Check
_________ _________
<CLR <CLR˘Exit Exit / ENT ENT˘OK> OK>
--DSC --DSC Menu-- Menu--
Set Set up up
Add:INDV Add:INDV ID ID
Add:Group Add:Group ID ID
DEL:INDV DEL:INDV ID ID
DEL:Group DEL:Group ID ID
Offset Offset Time Time
˘ MMSI MMSI Check Check
--DSC --DSC Menu-- Menu--
Select Select Item Item
Position Position Input Input
Received Received Calls Calls
˘ Set Set up up
Exit Exit