Icom IC-M504 - Manual (Page 67)

61
9
CONNECTIONS AND MAINTENANCE
9
■ MB-75 installation
An optional MB-75 FLUSH MOUNT KIT is available for
mounting the transceiver to a flat surface such as an instru-
ment panel.
CAUTION: KEEP the transceiver and microphone at least
1 meter away from your vessel’s magnetic navigation com-
pass.
q Using the template on the last page, carefully cut a hole
into the instrument panel (or wherever you plan to mount
the transceiver).
w Slide the transceiver through the hole as shown below.
e Attach the 2 supplied bolts (M5 ×
8 mm) on either side of
the IC-M504.
r Attach the clamps on either side of the IC-M504.
• Make sure that the clamps align parallel to the IC-M504’s body.
t Tighten the end bolts on the clamps (rotate clockwise) so
that the clamps press firmly against the inside of the in-
strument control panel.
y Tighten the locking nuts (rotate counterclockwise) so that
the IC-M504 is securely mounted in position as below.
u Connect the antenna and power cable, then return the in-
strument control panel to its original place.
t
y
End bolt
Locking nut
r
r
Clamp
Supplied bolt